http://www.todaysmachiningworld.com/forum/topic/updating-software Brought to you by Todays Machining World en-US Sat, 11 Sep 2010 00:03:23 +0000 http://bbpress.org/?v=1.0.2 q http://www.todaysmachiningworld.com/forum/search.php http://www.todaysmachiningworld.com/forum/topic/updating-software#post-581 Wed, 22 Jul 2009 23:47:51 +0000 Anonymous 581@http://www.todaysmachiningworld.com/forum/ <p>GiBBS cam is a good all around software, for the very best in the world mold making software I would choose TEBIS. If you make a lot of design changes than also look at Solid Works.</p> <p>Good Luck! </p> http://www.todaysmachiningworld.com/forum/topic/updating-software#post-511 Thu, 11 Jun 2009 15:32:23 +0000 Anonymous 511@http://www.todaysmachiningworld.com/forum/ <p>Have you looked at T-Flex yet. They have a 30 day trial fully functional. </p> http://www.todaysmachiningworld.com/forum/topic/updating-software#post-494 Mon, 18 May 2009 20:04:06 +0000 Anonymous 494@http://www.todaysmachiningworld.com/forum/ <p>Finally got the go ahead to get some new software. I have been using Edgecam but has not been updated for ten years, version 4.0 (yea I know). We are now getting into building our own molds in house now. Mostly an Okuma house in here if that means anything. We do have one VMC with a full fourth axis also. Does any of this incorporate mold design in it too? Also have twin spindle lathes with the live tools and one of those has the Y axis. Any suggestions would be appreciated because it will be another 13 years before I will get another system in here. </p>